Innovators and manufacturers of quality products for over 35 years
Home Where to buy Products Tech Talk About Us Retroseal Blog



Common causes of rust and corrosion in metal wall sheeting is when the metal sheet comes into contact with concrete or dissimilar flashings, caused by the bad practices of:

  1. Pouring the concrete up against the wall sheeting on the inside after the shed has been constructed (the lime in the concrete can cause corrosion);
  2. creating a step recess in the concrete and having the wall sheet contact onto or against it;
  3. using a dissimilar metal flashing as vermin proofing; or.
  4. simply having the overhanging wall sheeting contact the slab edge.

Campbells products eliminate rust and corrosion by providing an impassable barrier between the concrete slab and the wall sheet. Our RETROSEAL products are designed to be fitted to new or existing buildings

Back to top


The major problems encountered when using profile cut flashings is the shrink or creep of the sheet profile. This may be due to deliberate shrinking or expanding of the sheets to align them to run parallel with the building. It can also be caused by slight variations in manufacturers roll-mills.

RETROSEAL products address these problems in several ways.

  1. The product is made in sheet widths, to accord with sheet adjustment at lap. METAL products permit overlap; PVC flashings may have to be trimmed to length.
  2. The profiled area is set at 30 degrees so that it creates pressure where it meets the sheet profile. Where the sheet is in shrink (the profile on the sheet is deeper), it flexes down into the relaxed position. On creep (the profile on the sheet is shallower) it flexes up to the pressure position.
  3. On metal versions, the male profile can be tapped with a hammer handle deeper into the female underside or inside of the sheet. Decreasing the angle of the flashings has the effect of increasing the reach of the profile tongue into the sheet.

These factors result in the flashing being very forgiving of inconsistencies in roof sheeting.

Back to top


The BAL rating (Bushfire Attack Level) requirement of the Building Code of Australia 2011 specifies that mineral wool, metal mesh or non-combustible ember barriers be provided that allow a gap of no more than 3mm in roof, wall and floor junctions.

Campbells metal products help fulfil this requirement when installed in accordance with instructions. Profile cut metal flashings assist in overcoming potential corrosion that may be experienced with some fibrous barrier materials, by eliminating condensation buildup.

Although the BAL rating is designed to improve the performance of buildings under bushfire attack, there can be no guarantee that a building will survive a bushfire event on every occasion.

For buildings that have to meet the Australian Standard BAL regulation, it is the responsibility of the installer to be aware of these requirements, and to identify and close any gaps that exceed 3mm.

Back to top


The material used in these products is a high quality unplasticised (rigid) PVC which is suitable for indoor and outdoor applications. It contains a UV absorber, and all other ingredients are recommended for applications involving exposure to sunlight.

However, a shrinkage or distortion of about 0.5% can occur in very hot climates or conditions; however, this should not unduly affect the performance of the product. It is recommended that all PVC products be stored in their box and out of the sun in hot climates prior to installation.

PVC materials should be stored away from flammable substances as static buildup can occur. In the event of fire, our PVC products are self-extinguishing; however, if a fire occurs, fire fighters must wear breathing equipment as PVC compound forms hydrogen chloride if burnt.

Back to top

Phone 02 6644 9494     Fax 02 6644 9444     Email:
PO Box 130, South Grafton, NSW 2460
All CAMPBELL products carry IP protection in the form of Patent and/or Registered Design and/or Trade Mark.